韩国免费A级作爱片无码_亚洲欧洲精品成人久久av18_亚洲国产成人AV毛片大全_成年人在线免费看的惊悚动作片_一级爽片_爱爱免费

English | 中文版 | 手機版 企業登錄 | 個人登錄 | 郵件訂閱
當前位置 > 首頁 > 技術文章 > Rac 活性檢測試劑盒使用說明書

Rac 活性檢測試劑盒使用說明書

瀏覽次數:817 發布日期:2022-11-14  來源:本站 僅供參考,謝絕轉載,否則責任自負
Configuration-specific Monoclonal Antibody Based
Rac Activation Assay Kit
(30 Assays)  
Introductio
A. Background
Small GTPases are a super-family of cellular signaling regulators. Rac belongs to the Rho sub-family of GTPases that regulate cell motility, cell division, and gene transcription. GTP binding increases the activity of Rac, and the hydrolysis of GTP to GDP renders it inactive.

Currently the activation of Rac proteins is assayed with the binding of GTP-bound Rac to the p21-binding domain (PBD) of p21-activated protein kinase (PAK). This method is based on the observation that the active, GTP-bound Rac could bind to the PBD of PAK. However, the reproducibility of this method is poor. This is partially due to the relatively quick hydrolysis of GTP to GDP during the assay procedure, and the low binding affinity of PBD to Rac-GTP.

NewEast Biosciences Rac Activation Assay Kit is based on the configuration-specific monoclonal antibody that specifically recognizes Rac-GTP, but not Rac-GDP. Given the high affinity of monoclonal antibodies to their antigens, the activation assay could be performed in a much shorter time. This assay provides the reliable results with consistent reproducibility. 

B. Assay Principle
NewEast Biosciences Rac Activation Assay Kit uses configuration-specific anti-Rac-GTP Mouse monoclonal antibody to measure Rac-GTP levels in cell extracts or in vitro GTPγS loading Rac activation assays. Anti-Rac-GTP mouse monoclonal antibody is first incubated with cell lysates containing Rac-GTP. Next, the GTP-bound Rac is pulled down by protein A/G agarose. Finally, the precipitated Rac-GTP is detected through immunoblot analysis using Anti-Rac Rabbit Polyclonal Antibody.

C. Kit Contents This kit contains enough reagents for approximately 30-35 pull down assays.



D. Materials Needed but Not Supplied
1. Stimulated and non-stimulated cell lysates
2. Protease inhibitors
3. 4℃ tube rocker or shaker
4. 0.5 M EDTA at pH 8.0
5. 1.0 M MgCl2
6. 2X reducing SDS-PAGE sample buffer
7. Electrophoresis and immunoblotting systems
8. Immunoblotting wash buffer such as TBST (10 mM TrisHCl, pH 7.4, 0.15 M NaCl, 0.05% Tween-20)
9. Immunoblotting blocking buffer (TBST containing 5% Nonfat Dry Milk or 3% BSA)
10. ECL Detection Reagents 

E、Example Results
The following figure demonstrates example results seen with the Rac Activation Assay Kit. For reference only.

Rac Activation Assay.
MEF cells were treated with (lane 2) or without (lane 1) PDGF. Cell lysates were incubated with an antiRac-GTP monoclonal antibody (Cat. # 26903) (top panel). The precipitated active Rac was immunoblotted with an anti-Rac rabbit polyclonal antibody (Cat # 21003). The bottom panel shows the Western blot with anti-Rac of the cell lysates used (5% of that used in the top panel).  

Assay Procedure
A. Reagent Preparation  
1X Assay/Lysis Buffer:
Mix the 5X Stock (Cat. # 30301) briefly and dilute to 1X in deionized water. Just prior to usage, add protease inhibitors such as 1 mM PMSF, 10 µg/mL leupeptin, or 10 µg/mL aprotinin

B. Sample Preparation
Adherent Cells

1. Culture cells (one 10-cm plate, ~107 cells) to approximately 80-90% confluence. Stimulate the cells with activator or inhibitor as desired.
2. Aspirate the culture media and wash twice with ice-cold PBS.
3. Completely remove the final PBS wash and add icecold 1X Assay/Lysis Buffer (See Reagent Preparation) to the cells (0.5-1 mL per 10 cm tissue culture plate).
4. Place the culture plates on ice for 10-20 minutes.
5. Detach the cells from the plates by scraping with a cell scraper.
6. Transfer the lysates to appropriate size tubes and place on ice.
7. If nuclear lysis occurs, the cell lysates may become viscous and difficult to pipette. If this occurs, lysates can be passed through a 27½-gauge syringe needle 3- 4 times to shear the genomic DNA.
8. Clear the lysates by centrifuging at 12,000 x g and 4℃ for 10 minutes.
9. Collect the supernatant and store the sample (~1-2 mg of total protein) on ice for immediate use, or snap freeze and store at -70℃ for future use.

Suspension Cells
1. Culture cells and stimulate with activator or inhibitor as desired.
2. Perform a cell count and then pellet the cells through centrifugation.
3. Aspirate the culture media and wash twice with ice-cold PBS.
4. Completely remove the final PBS wash and add icecold 1X Assay/Lysis Buffer (See Reagent Preparation) to the cell pellet (0.5-1 mL per 107 cells).
5. Lyse the cells by repeated pipetting.
6. Transfer the lysates to appropriate size tubes and place them on ice.
7. If nuclear lysis occurs, the cell lysates may become viscous and difficult to pipette. If this occurs, lysates can be passed through a 27½-gauge syringe needle 3- 4 times to shear the genomic DNA.
8. Clear the lysates by centrifuging at 12,000 x g and 4℃ for 10 minutes.
9. Collect the supernatant and store sample on ice for immediate use, or snap freeze and store at -70℃ for future use.

C. In vitro GTPγS/GDP Protein for Positive and Negative controls  
Note: In vivo stimulation of cells will activate approximately 10% of the available Rac, whereas in vitro GTPγS protein loading will activate nearly 90% of Rac.
1. Aliquot 0.5 mL of cell extract (or 1 µg of purified Rac protein) into two microcentrifuge tubes.
2. To each tube, add 20 µL of 0.5 M EDTA (final concentration of 20 mM).
3. Add 5 µL of 100 X GTPγS (Cat. # 30302) to the first tube as a positive control.
4. Add 5 µL of 100 X GDP (Cat. # 30304) to the second tube as a negative control.
5. Incubate both tubes at 30℃ for 30 minutes with agitation.  
6. Stop loading by placing the tubes on ice and adding 32.5 µL of 1 M MgCl2 (final concentration of 60 mM).

D. Affinity Precipitation of Activated G Protein
1. Aliquot 0.5-1 mL of cell lysates (about 1 mg of total cellular protein) to a microcentrifuge tube.
2. Adjust the volume to 1 mL with 1X Assay/Lysis Buffer (See Reagent Preparation).
3. Add 1 µL anti-Rac-GTP antibody (Cat. # 26903).
4. Prepare the protein A/G Agarose bead slurry (Cat. # 30301) by resuspending through vertexing or titrating.
5. Quickly add 20 µL of resuspended bead slurry to above tube.
6. Incubate the tube at 4℃ for 1 hr with gentle agitation.
7. Pellet the beads through centrifugation at 5,000 x g for 1 min.
8. Aspirate and discard the supernatant (making sure not to disturb or remove the bead pellet.
9. Wash the beads 3 times with 0.5 mL of 1X Assay/Lysis Buffer, centrifuging and aspirating each time.
10. After the third wash, pellet the beads through centrifugation and carefully remove all the supernatant.
11.Resuspend the bead pellet in 20 µL of 2X reducing SDS- PAGE sample buffer.
12. Boil the sample for 5 minutes.
13. Centrifuge it at 5,000 x g for 10 seconds. 

E. Western Blot Analysis
1. Load 15 µL/well of pull-down supernatant to a polyacrylamide gel (17%). It is recommended to include a pre-stained MW standard (as an indicator of a successful transfer in step 3 below).
2. Perform SDS-PAGE following the manufacturer’s instructions.
3. Transfer the gel proteins to a PVDF or nitrocellulose membrane following the manufacturer’s instructions. Note: Steps 4-11 are at room temperature with agitation
4. Following electroblotting, immerse the PVDF membrane in 100% Methanol for 15 seconds, and then allow it to dry at room temperature for 5 minutes. Note: If Nitrocellulose is used instead of PVDF, step 4 Should be skipped.
5. Block the membrane with 5% non-fat dry milk or 3% BSA in TBST for 1 hr at room temperature with constant agitation.
6. Wash the blotted membrane three times with TBST, 5 minutes each time.
7. Incubate the membrane with Anti-Rac Rabbit Polyclonal Antibody (Cat. # 21003), which is freshly diluted 1:50~500 (depending on the amount of Rac proteins in your sample) in 5% non-fat dry milk or 3% BSA in TBST, for 1-2 hr at room temperature with constant agitation or at 4℃ overnight.
8. Wash the blotted membrane three times with TBST, 5 minutes each time.
9. Incubate the membrane with a secondary antibody (Cat. # 29002), which is freshly diluted 1:1000 in 5% non-fat dry milk or 3% BSA in TBST, for 1 hr at room temperature with constant agitation.
10.Wash the blotted membrane three times with TBST, 5 minutes each time.
11.Use the detection method of your choice such as ECL
發布者:武漢費斯德生物科技有限公司
聯系電話:027-63487286
E-mail:nebio0923@163.com

用戶名: 密碼: 匿名 快速注冊 忘記密碼
評論只代表網友觀點,不代表本站觀點。 請輸入驗證碼: 8795
Copyright(C) 1998-2025 生物器材網 電話:021-64166852;13621656896 E-mail:info@bio-equip.com
主站蜘蛛池模板: 99国产欧美另娄久久久精品 | 国产精品一久久香蕉国产线看观看 | 人妻巨大乳挤奶水HD免费看 | 人妻丰满AV无码久久不卡 | 免费观看一级黄色片 | 少妇高潮出水视频 | 国产不卡av在线 | 最新中文字幕免费看影视 | 亚洲欧美成人久久综合中文网 | 久久久99日产 | 又黄又爽又猛1000部A片 | 高清无码内谢 | 中文字幕第5页 | 狠狠插久久综合网最新章节 | 亚洲AV成人片无码网站网 | 麻豆第一页 | A片在线观看免费视频网站 四虎影视8848hh四虎在线 | 美女脱裤子让男生捅 | 国产一极内射視颍一 | 女子初尝黑人巨嗷嗷叫 | 久久蜜桃资源一区二区老牛 | 疯狂做受XXXX高潮欧美日本 | 日韩综合AV一区二区三区在线 | 国产欧美人体大胆一区亚洲性爱一级片 | 4438x五月| 中文第一页 | 日本久久久久久级做爰片 | 1000部禁片未18勿进免费观看 | 國产一二三内射在线看片 | 人妻精品制服丝袜久久久 | 亚洲一区二区三区四区 | 一级一片在线观看 | 国产午夜激无码AV毛片 | 天天看AV片在线观看 | 日本三级精品 | 我朋友的母亲在线观看 | 欧美人与禽猛交狂配 | 久久婷婷五月综合色国产 | 久久精品国产亚洲AV蜜臀 | 国产啪视频1000部免费 | gogogo高清在线观看视频中文 |